23/24/25/26mm rear 309 anti roll bar anyone???
well any garage should have one.
Well just find out which joint has gone and just by the joint.1.9 shafts only tho and cheaper than buying a recon/new shaft
um fuel pressure problems maybe
reverse is in a better place and you havent got the silly clutch levers etc
well you should of put a BE3 in for starters.iv got a BE1 1.6 gearbox knocking about somewhere il try and count the teeth on that if i get a chance.if...
you should have battary voltage there.try putting a live wire from the battary to the solenoid and if it starts the starter moters o.k.if i remember r...
Yeah you can my best mates dad put a lsd in 1 without taking the gearbox out.just gotta take the bottom engine mounting off i think.
well it road rallying you need bottom end power and torque and with 16v you have to keep the reving over 5 grand to make them pull where 8v got abit m...
thay only made the throttle body water heated to stop it icing up when its realy cold
it could be the rear axle front rubber bushes gone.had them go on ma 309 and you wont find play in them much when there on there car.
you cant use the eccentric top strut mounts the with standed shock cause the hole is offset to adjust castor/amber.the spring will touch the inner win...
A Gpa oli pump sring will only give you better oli pressure with the engine is reving you will still have crap oli pressure at idle.the reason why you...
i wouldnt bother unless your getting the bootam end lighted and balanced
yeah dont try it unless you realy know wot your doing.u need a dti gauge and a crank locking tool has to be a realy good fit tho.and it depends on wot...