The main problem with space is being able to tighten the tiewrap properly, but if you get under from the wheel side then you can just about get it on ...
It does depend on which side, the offside does go straight into the box and will run, the near side runs through a section of the engine [clamp] and t...
quote fugm:HI on the later turbo deisel engine the fuel cut of solioed is in cased in a metal box which also has a chip in there which reads the sign...
yeah I had noticed that, didn't really think to blame that for it, and the new shiny inlet wasn't too bad, to be honest If it's the one that takes a p...
quick question for mattenb, in your username details where it reads what you've done to your car - what are the benifits of removing the EGR valve?
Right, I was confused by the parts department I spoke to, asking me if it's outer or inner??? but I'd gather they may be refering to a seal on the oth...
quote mattanb:never done a 1.9td one but have done others. be careful when puting the new seal over the end of the crank as they rip easy and ull have...
quote doddger82:if its still strugling to start might have an air leak?I managed to get it started after swapping over to my original fuel pump,...
There tiny 🙁 here's some links to them
Here's some pics............off to find out why there's oil on the road near where my car was parked 😡
All back on, fired up straight away, tried to make a mark to time the old with the new, seems to be running ok, bit poor on start but im suspecting so...
I've since spoken to a couple of peugeot specialists in Sheffield and Worksop, both have said it's the immobiliser built behind it all, which explains...
my cam belt pulley smashed after a bearing in the tensioner went down on the auxiliary belt, it pulled the belt off and dragged it to the point of sna...
I found corroded pipes when I removed the radiators to remove the engine in my D Turbo.........the pipes are a mess, I was planning on re-gasing when ...