1.6 pistons in a 1.9 engine will fit and increase compression ratio.You may need to play with the igntion timing afterwards (i.e. retard)
Aha it all becomes very clear!So effectively you should have the ultimate budget build which will be great to see.i.e. not getting into the ho...
I know it may not be something you want to talk about or to be public knowledge but what has exactly happened with the spec?I'm purely asking as w...
At the moment I have a 309 but since the discovery it was mean to be a Talbot Arizona I am "re-badging" it accordingly. as per this thread:I ju...
Personally I would junk all the fuel bits off the carbs, block up all those little holes, remove the chokes, have a manifold machined or made - reckon...
tilt the seat forwards?The front one is trickiest because usually the torx bit on a ratchet is just too long - so leave it till last and lift the ...
I still haven't got a car else I'd help :swhat with moving soon, a couple of weekends away planned and not having a car I'd be useless right now!
AFAIK the actually clutch is the same between BE1 and BE3 its just the way the release arm/bearing works that differs.
have to either:1. Get an Mi PAS setup - it attaches to the exhaust cam, has a reservoir and then the pipes to the rack2. Go electric - 106 Gti...
Get your profile updated and member status put on and then you'll never miss out! 🙂Its the easiest way for our group leaders/committee to identif...
quote jas:any track time left? wouldnt mind 2 slots, any free entry tickets letft too. I think im pushing my luck though. Cheers These are only av...
I've not posted yet as I was thinking I'd never been pulled but just remembered a few :blackeye:1st: 1998 - was 17, 5 people in the car, doing a...
lower the rad re-angled plate from QEP 405 loom, ECU and AFM