quote Mikey82:and im not at all sure about engine mounts either so u will have to check up on them because your 1.1 is defiantly thinner than the 1.6 ...
for the ecu you need the VTR one unlocked, with immobiliser box and the little transponder chip from the key. As for the wiring loom as mat said chang...
bugger, its Ashford, too far for me this time I'm afraid, was hoping to make up for last times lapse in my memory 🙁
i'd love to let people rip into him, but image of the club and all that. to be honest I think he should be banned outright, dont want to be snobbish o...
dont be scared, its easy! you just need to know the limits of your car if your going to push it hard 😀Click HERE for membership mate :hat:
aye when Johns not workin sleepin or lookin after the littl'un we'll get it sorted 🙂 dont worry something will happen!! 😀
weklcome aboard mate! where abouts in sussex are you from? As Ali said the meets are first monday of every month, 8pm onwards down the potter, would b...
yeah should be a rubber o-ring, they tend to go flat and hard after a few years use, not expensive from pug to buy and easy to swap 🙂
quote Woz_106:i'm running good old 3 stud i'm affraid AZ but cheers for the offerNo worries chap 🙂
new suspension (yep again!) - on route GTI rear ARB - Dan I'll call you tomorrow! lol finish sorting the rest of the dodgy paintwork / stone chips ...
didnt have any trouble with my 180 calipers and discs and I beleiev the calipers are the same size just different sized pistons. no grinding required!...
could be a split vacuum pipe, or at worst something like a lambda sensor or idle control valve. Does it do it all the time cold or hot e.t.c. e.t.c.?